Tag Archives: Carpenters glue

I’m a driftwood junkie….

Standard

Going for a walk on the beach means taking along a bag just in case I find a neat piece of driftwood.  Well, after awhile, those neat pieces tend to accumulate and gather in the garage – so I had seen an idea somewhere to make a driftwood shelf.  Idea!  That would be awesome to make and use up some of the bits of wood..

IMG_1937

I seem to be in a gnome and fairy mode right now and I like to make the little funny guys with big noses.  These seemed to just fit on the shelf with candles once I got it all put together.  It’s a fun project and here is how to make it.

IMG_1851

I began by going through my bits of driftwood finding pieces that would fit for the backdrop and then could be screwed onto the shelf part.

IMG_1865

I added a short piece of backing board (in this case a piece of trim wood) and drilled through the driftwood and the shelf board using screws for strength.

IMG_1866

Predrilling holes just a bit smaller than the screws really helps!

IMG_1868

Looking at the piece from the back. Once all the screws were in, I used carpenters glue to add a little more strength where each piece joined the backing board.

IMG_1869

This is the front of the piece and you can see that the backing board sits about an inch above the shelf piece. At this point it needs to be propped up. Then I had to find some smaller pieces of driftwood to cover the backing board showing below the shelf.

IMG_1933

Laying it flat on the counter, you can see where the driftwood was attached to the backing board at the bottom. Sorry, the photo doesn’t give much of an idea of flats and uprights.

IMG_1930

I added this branch across the upright pieces and wired it on followed by gluing with Carpenters Glue.

IMG_1935

One more curvy piece of driftwood was added to the very top, being glued on and also several small flat pieces along the top of the backing board so it can’t be seen at this angle. I placed a small glass under one end to show what it will look like when hung on the wall.

IMG_1937

And here is the finished piece – you can add whatever you wish to the shelf to make it seasonal. I Forgot to mention that I added a saw tooth hanger at the back of the two tallest pieces of driftwood and it holds the piece perfectly on the wall.

This was a fun project to do, and it certainly helped use up some of the driftwood.  Gosh, the weather here is so beautiful, perhaps it’s time to go for another beach walk!

Wishing you a happy and peaceful new year, I won’t be posting until sometime in March as I’m taking a bit of a holiday away.  See you in the spring!